14 E-MU Systems
Setup
Basic Setup
Connection
Instructions
Power Switch & AC Receptacle
The AC power switch is located on the rear panel. There is no 110/220 Volt
power selector switch since Vintage Keys utilizes an auto-switching power
supply which accepts from 100V-250V, 50-60Hz.
MIDI Output
Vintage Keys can control other MIDI instruments by connecting a MIDI
cable between the MIDI out of Vintage Keys and the MIDI Input of the
other instrument.
The Right Main output
jack carries a mono mix of the
left and right channels when the
Left Main plug is not plugged in.
The Left Main output jack is a
stereo jack carrying both
channels when the right output
jack is empty.
Outputs
In order to reproduce the wide dynamic range and frequency response, use
a high quality amplification and speaker system and a stereo setup is highly
desirable The headphone output is the same as the Main output signal. The
headphone jack is located on the left side of the front panel.
Footswitch & Footpedal
Connect a momentary footswitch and a Control Pedal for additional
control. Vintage Keys auto-senses either normally-open or normally-closed
switches. See page 15 for foot pedal wiring information.
Basic Setup
SUB 1 MAIN
To Next Page
Loading...
