Footrest Trim:
It is not essential to fit the rear trim, however it adds to the finish and
style of your E RIDER. Select four short bolts with crosshead screw
tops. Identify the rear foot rests. Line up the trim over the fixing holes
with the circular part towards the rear wheel. Put the bolts through the
holes. Tighten with a screwdriver and 10mm spanner.
Do not be concerned that you are left with surplus screws and/or bolts.
It is normal practice to pack the bike with more fixings than are
required.
Congratulations!!!
Your E RIDER is ready for its first full charge and then a road test.
Enjoy it, and thank you for becoming a member of the E RIDER
community.
To Previous Page
Loading...
