E Rider 30 User Manual

USER MANUAL AND ASSEMBLY INSTRUCTIONS
Congratulations, once again, on buying an E RIDER Model 30!!!!
USER MANUAL
We are sure you will be excited by the delivery of your brand new bike
and you will be eager to start using your E RIDER as soon as possible.
However you will need to be a little patient as there are some
important things to be done before you can ride it.
Firstly, the bike cannot be fully assembled for safe delivery so please
refer to our Assembly Instructions below and follow them closely to
put your bike together safely.
Secondly, the Model 30 is a registered vehicle and you must
register it with the DVLA before you can legally ride it on a UK road.
To do this you need to do the following.
1) Order form V55/4 from DVLA. You can do that online HERE You
should also download the guide to completing it HERE
2) Take a note of the Chassis Number of your bike and email the
information to info@eriderbikes.com
3) We will send you by return the Certificate of Conformity, NOVA
reference, Certificate of Newness, and Commercial Invoice for your
bike by post.

E Rider 30 Specifications

General

Brand	E Rider
Model	30
Category	Scooter
Language	English

Summary

User Manual and Registration Guide

Initial Setup and Registration Overview

Outlines initial bike setup and the first steps for UK registration.

Completing Registration and Licensing

Details subsequent registration steps and obtaining a license plate.

Battery Charging and Storage Procedures

Instructions for charging the battery after transport and storage.

Security and Identification Record

Guide to recording chassis number and purchase date for security.

General Usage and Care

Load Capacity and Weather Conditions

Details maximum load and advice for riding in wet or snowy weather.

Battery Maintenance and Charger Use

Recommends battery charging frequency and using the supplied charger.

Bike Operation

Starting and Ignition Sequence

Explains how to start the bike using the ignition key and operate controls.

Handlebar Controls Overview

Identifies and describes all controls located on the handlebars.

Riding Performance and Safety

Covers speed, terrain impact, and critical warnings about motor operation.

Assembly Instructions

Delivery and Initial Unpacking

Describes the delivery process and how to unpack the bike from its packaging.

Frame Dismantling and Wire Cutting

Instructions for dismantling the protective steel frame and cutting securing wires.

Component Identification and Fitting

Lists essential components and shows how to unpack them.

Installing Front Wheel and Handlebars

Step-by-step guide for fitting the front wheel and handlebars.

Final Assembly and Charging

Covers fitting trim, adjusting brakes/lights, and the final charging step.