Operating Instructions
1. ON/OFF
Press the switch for 3 seconds, and the display will light up, indicating
the power is on. Press for 3 seconds if you want to turn it o. It will
turn o automatically if you don’t use it for 3 minutes.
2. Speed control
Press the right thumb accelerator to control the speed (1-30km/h).
3. Breaking control
Press the left thumb and the electronic magnetic brake will be acti-
vated. The greater pressure you put, the greater breaking force will
be.
4. Horn
If you turn on the power, when pressing the horn button, it will hoot.
5. Led headlight
In manual mode: Press the On/O Light button when needed and
there will be a sign in display, indicating the light turns on. Press
the button again when you do not need the light. The scooter Keep
pressed for a few seconds. Is equipped with a sensor light that de-
tects the need of light. The light will turn on automatically (auto light
mode) if the sensor detects poor ambient light until the sign “Auto”
disappears from the screen.
For example: when it is cloudy weather and the auto light mode is
on, the light turns on. If the daylight is proper, the auto light mode
detects the light and the Headlights will go o after 5 seconds. On
auto light mode, the display is also lighted depending on the ambient
light. If the scooter is on auto light mode, you can go to manual mode
by pushing the On/O Light Button.
6. Mileage show
When the display is powered on, It shows two modes: ODO and trip.
You can change it by pressing the settings button. In “Trip” mode,
press the setting button (S) for 3 seconds and it will clear the trip.
7. Emergency
In an emergency, it’s recommended to use the foot brake.
To Next Page
Loading...
