Display Functions
Speedometer, power indicator, error code indicator, on/off -button for light, cruise control, gear switch, and
gear indicator.
Error codes:
E-1 - Motherboard/Display – Check connections between display and motherboard
E-2 - Motherboard/Motor – Check connections between motherboard and motor (coloured cables)
E-3 - Brake handle – Brake handle must be replaced
E-4 - Motherboard – Fault on the motherboard
E-5 - Battery – Battery must be charged or replaced
E-7 - Gas accelerator – Gas accelerator must be replaced
E-8 - Motherboard/Motor – Check connections between motherboard and motor (white plug)
Speedometer
Unit: KM/H
Speed signals comes from the motor via the controller to the display.
The indicated speed depends on the motor signal and the wheel diameter.
Display - power button
• Hold down the power button (long press) to turn the scooter on and off.
• To turn on the lights the scooter must be turned on, and the power button must be short pressed once.
• To alternate between different modes, short press the power button twice (quickly).
3.2 Display & Error Codes
EN
To Next Page
Loading...
