E-Wheels EW-01 - Safety Requirements; Driving Surface

9
iii. Stand in front of the scooter and raise each hand grip until
each handlebar grip locks in place.
iv. Adjust the handlebar tube to desired height by simply turning
the tube adjust counter clockwise. Press the silver button
located on the front of the handlebar tube to raise or lower
handlebar to desired position. Once desired handlebar height
is secured then turn the tube adjustor clockwise to lock the
handlebar in place.
Safety Requirements
Driving Surface
Speedy has the best stability under the normal driving conditions (dry, level
ground with concrete or asphalt) Extra care must be taken when riding on
other surfaces (grass, gravel etc.)
DO NOT exceed the specified climbing angle (0-18 degrees). Please read the
manual instruction completely before operation.
 Check the physical condition before driving the scooter.
 ALWAYS SLOW DOWN WHEN TURNING
 Speedy can be used in short grass and hard gravel safely with caution.
 Avoid driving in loose gravel, covered soil and sandstone.
 Do not drive the scooter in unknown road conditions.
 Speedy can ride over small obstacles within a certain height, but you must
minimize the speed and slowly drive over the obstacle.
 Do not operate the scooter before you have fully read and understood
this manual.