Your EW-SCOOTER comes with the following items in the box. Please locate
all of the following:
PACKAGE CONTENTS
1. EW-SCOOTER
2. 24V Battery Charger
3. Front Wheel
4. Tool Kit
5. Product Handbook
GETTING STARTED
Please read and understand these instructions and the OPERATING
PROCEDURES
section, prior to starting or riding your
EW-SCOOTER
Fig. 1
Fig. 2
Fig. 3
1. Carefully remove the EW-SCOOTER from
the box.
2. Locate the enclosed front when and attach
it to the front fork of the scooter. See
figure 1.
3. Secure the front wheel using the enclosed
tools to tighten the front wheel nut/bolt. See
figure 2.
4. To unfold the scooter, loosen the handlebar
folding clamp located at the base of the
handlebars. Figure 3
5. Fully extend the handlebars to their upright
position, and then tighten the clamp
securely. Fig. 4
6. Attach Throttle and Brake Handle Grips by
inserting the handle grips into the
handlebar posts until the gold snap pin
clicks into place. Fig. 5
7. Raise the T-
position until the gold snap pin locks into
place. Tighten the clamp to secure the
handlebar in place. Fig. 6
To Next Page
Loading...
