EasyManua.ls Logo

E-Wheels EW-54 - Routing Operation; Battery Installation and Power Check; Tire Pressure and Brake Verification; Riding Controls and Assisted Pedaling

E-Wheels EW-54
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Committed to Quality and Reliability!
5
3) Sometimes the front wheel is taken off
for the convenience of packing. So when the electric tricycle is taken off from the
frame, please assemble the front wheel and adjust the handlebar at first.
4) The seat is
adjustable; please adjust the seat post according to your
height. The seat height is adjusted with either a quick
release lever or a nut and bolt. Insert seat post to at least
the minimum insertion line marked on the post. Tighten
the adjusting nut by hand and move the hand release
lever to the closed position.
5) Pedals are marked “L” and “R” on end. Screw pedal
marked “L” into left side of crank.
6) Please check the battery wire
connection to make sure the power supply of the electric tricycle.
Routing Operation
Fix the properly charged battery into the battery trough on the body and lock it properly.
Please firstly check whether the power is low, and you have to charge the battery before
ride if it is low.
Be sure the tires have enough air. A low tire pressure risk rim pinching (tube failure) and
lowers your range (distance per charge). The tire pressure should be 2.1-2.5kg/cm²
Verify the proper adjustment and function of the brakes.
Insert the key into the power switch key hole and turn to the position ON to connect the
power and then you can ride.
Hold onto the handlebars with both hands. Assume a well-balanced position. Your right
hand will control the accelerator. Twist the accelerator slowly to avoid a sudden rush of
speed forward. The speed of the electric tricycle will increase as you twist the
accelerator more. Release the accelerator and apply the brakes to stop the tricycle.
You will control the speed of the electric tricycle by using both the accelerator and the
brakes. When the brake handle is squeezed it cuts power to the accelerator
.
The electric tricycle is 1:1 pedal assisted tricycle, when you turn
on the power of the tricycle by the ignition switch, you can also
pedal it to start the motor. Also if the battery runs out the power,
you can pedal it like normal tricycle.

Related product manuals