E-Z-GO 2Five User Manual

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
60 2Five Owner’s Guide
Remove the protective clear plastic from the seat bottom and back rest before placing the vehicle in ser-
vice.
Fig. 6 Initial Service Chart
BRAKE BURNISHING PROCEDURE:
For new vehicles or after replacement of brake pads or rotors, it is recommended that approximately 20
stops with moderate braking from 20 mph to 5 mph should be made without coming to a complete stop.
This procedure will assure that your new brakes will function to their full potential and maintain maximum
wear resistance.
Determine and record the braking distance required to stop the vehicle for future brake performance tests.
ITEM SERVICE OPERATION
Batteries Charge batteries
Seats Remove protective plastic covering
Brakes Check master cylinder fluid level & brake operation
Perform brake burnishing procedure
Establish acceptable stopping distance
Tires Check air pressure (see SPECIFICATIONS)

E-Z-GO 2Five Specifications

General

Brand	E-Z-GO
Model	2Five
Category	Electric Vehicles
Language	English