E-Z-GO 2Five User Manual

2Five Owner’s Guide 87
MAINTENANCE PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
THIS PROCEDURE SHOULD ONLY BE PERFORMED BY QUALIFIED TRAINED
PERSONNEL.
Make sure that the key is in the ’OFF’ position and the tires are chocked to prevent the vehicle moving;
then perform the following:
1. Locate the ’Auxiliary Power’ line (3) and remove the weather pack seal (4) from the connector.
2. Locate the ’Primary Power’ line connector (1) and disconnect it from line (2).
3. Connect the ’Auxiliary Power’ line (3) to the ’Primary Power’ line (1) which will release the brake. If the
tires are not chocked and the vehicle is not on flat ground the vehicle will move immediately.
4. Move the vehicle to desired, safe location and chock the tires immediately.
5. Disconnect the ’Auxiliary Power’ line (3) from the ’Primary Power’ line (1).
6. Connect the ’Primary Power’ line (1) to line (2).
7. Replace the weather pack seal (4) on the ’Auxiliary Power’ line connector (3).

E-Z-GO 2Five Specifications

General

Brand	E-Z-GO
Model	2Five
Category	Electric Vehicles
Language	English