Page 29
GENERAL SPECIFICATIONS
Owner’s Manual and Service Guide
MPT
™
1000
STANDARD EQUIPMENT:
WEIGHT (without batteries) 809 lbs. (374 kg)
TIRES (4 ply rated) 18 x 8.50 x 8 (4 ply rated)
TIRE PRESSURE 18 - 22 psi (120 - 150 kPa)
LOAD CAPACITY 1000 lbs. (454 kg) (including operator, passenger, cargo and accessories)
GROUND CLEARANCE 4.75 in. (12 cm) at differential
MAXIMUM HEIGHT 65 in. (165 cm) with top
CHASSIS Welded high yield strength tubular steel with powder coat paint
BODY AND FINISH Front: Flexible, impact resistant panels. Color coat/clear coat finish
Rear: Lightweight, replaceable steel panels
SAFETY Dash mounted key switch, reverse warning indicator, ‘deadman’ accelerator control, integral
handgrip on hip restraints, manual forward/reverse selector with ‘neutral’, electric horn
STEERING WHEEL Dual handgrips and pencil holder integrated with clipboard
BRAKES Dual rear wheel mechanical, self-adjusting drum brakes. Combination service / park brake with
automatic parking brake release (accelerator kick-off)
FRONT SUSPENSION Heavy duty leaf springs with hydraulic shock absorbers
REAR SUSPENSION Heavy duty leaf springs with hydraulic shock absorbers
STEERING Self-compensating single reduction rack and pinion
DASH PANEL Scuff resistant with four drink holders
SEATING Formed fabric backed vinyl covers over cushion foam. Seating for operator and one passenger
MOTOR 48 volt DC high efficiency shunt wound, brazed armature, solid copper windings
DRIVE TRAIN Direct motor shaft connected to transaxle pinion shaft
ELECTRICAL SYSTEM 48 volt DC, eight, 6 volt deep cycle storage batteries
SPEED CONTROL Solid State continuously variable speed controller, 400 amp rated
TRANSAXLE High efficiency differential with helical gears, 14.7:1 ratio
SPEED 13 ± .5 mph (21 ± .8 kph)
CHARGER Fully automatic line compensating, 48 volt output
Specifications subject to change without notice
To Next Page
Loading...
Need help?
General
