Why is my Earlex CombiVac WD1000 Vacuum Cleaner not picking up?
If your Earlex Vacuum Cleaner motor is running but not picking up debris, here's what you should do: First, check if the cleaner needs emptying. Next, inspect the system for any blockages and clear them. Finally, make sure that both the foam and paper filters are clean and undamaged.
What to do if my Earlex CombiVac WD1000 Vacuum Cleaner motor does not operate?
If the motor of your Earlex Vacuum Cleaner isn't working, start by verifying that the unit is properly plugged in and switched on. Then, check the fuse in the plug, replacing it with a 13amp fuse if necessary. If you're using an extension lead, also check the fuse in that lead.
Why does my Earlex CombiVac WD1000 motor make a high-pitched noise?
If your Earlex Vacuum Cleaner motor is making a high-pitched noise, check if the cleaner needs emptying and whether the float valve has been activated.
How to fix dust blowing from the outlet of my Earlex Vacuum Cleaner?
If you notice dust or grit blowing from the outlet of your Earlex Vacuum Cleaner, ensure that the filter is correctly fitted. If you are using a heavy-duty filter, verify that it is fully pushed into position.
Explains the two types of filters provided: foam and paper.
Instructions for using the foam and paper filters for dry pickup.
Instructions for using only the foam filter for wet pickup.
Automatic shut-off mechanism for liquid full detection.
Procedure for safely emptying the recovery tank.
How to use the unit as a blower and its applications.
Cleaning and upkeep instructions for the unit and filters.
Electrical connection safety and wiring guide.
Overview of Earlex steam wallpaper strippers.
General| Brand | Earlex |
|---|---|
| Model | CombiVac WD1000 |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page
