What to do if my Earlex Vacuum Cleaner motor runs but doesn't pick up?
If your Earlex Vacuum Cleaner's motor is running but it's not picking up dirt, first ensure the switch is set to the continuous mode (position l). Then, empty the cleaner if it's full. Next, inspect the system for any blockages and clear them. Finally, check the filters to make sure they are clean and undamaged.
Why doesn't my Earlex Vacuum Cleaner motor operate?
If the motor of your Earlex Vacuum Cleaner isn't working, verify that the unit is properly plugged in and switched on. Inspect the fuse in the plug and replace it only with a 13amp fuse if needed. If you're using an extension lead, check its fuse as well.
How to fix high pitched noise from Earlex Vacuum Cleaner?
If your Earlex Vacuum Cleaner motor is making a high-pitched noise, it might be time to empty the cleaner. The noise could indicate that the float valve has been activated.
Covers unattended use, electrical hazards, handling of hazardous materials, and user restrictions.
Ensuring correct operation, handling motor noise, blockages, lifting, and mode changes.
Details on fitting and using the combined wet/dry cartridge filter.
Description of the automatic liquid shut-off mechanism.
Common problems and their solutions for the unit.
Safety instructions and wiring for mains power connection.
General| Power | 1200W |
|---|---|
| Capacity | 20L |
| Cable Length | 5m |
| Type | Wet/Dry |
| Frequency | 50Hz |
To Next Page
