Why EarthQuake 600050V Trimmer head does not retain line?
If the trimmer head of your EarthQuake Trimmer does not retain the line, it might be because the trimmer line is not properly attached. Also, a broken line retainer could be the cause, requiring replacement of the trimmer head assembly. Finally, ensure you are using the correct size trimmer line (0.155 diameter).
General| Brand | EarthQuake |
|---|---|
| Model | 600050V |
| Category | Trimmer |
| Language | English |
Emphasizes knowing the product, following instructions, and outlines essential safety practices for operation.
Provides a key to understanding the meaning of different hazard symbols found on the trimmer and in the manual.
Highlights the risks associated with children near the trimmer and provides safety guidelines to prevent accidents.
Instructs on how to properly add oil to the crankcase and gasoline to the fuel tank before initial use.
Step-by-step guide on how to safely start the engine, including priming and recoil starter use.
Provides instructions for changing the engine oil, including draining and refilling procedures.
Explains how to replace trimmer line for performance and balance, and how to adjust line lengths.
Lists common causes and their corrections for when the engine fails to start.
Identifies potential causes and solutions for the engine running poorly or erratically.
Addresses engine overheating and problems with the engine not stopping, offering solutions.
To Next Page
