EasyManua.ls Logo

EarthQuake 9800KC - User Manual

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FRANÇAISFRANÇAIS ENGLISHENGLISHESPAÑOLESPAÑOL
English: pages 2-13
Français: pages 14-25
Español: páginas 26-37
Operator's Manual
Manuel de l’utilisateur / Manual del operador
Original Operating Instructions
Instructions traduites de l’original / Instrucciones de originales de operación
Two-Man
Earth Auger Powerhead
9800 Series
Bloc moteur de tarière deux personnes série 9800
Cabezal de potencia de barrena para abrir agujeros para
postes para dos personas serie 9800
Get parts online at
Pièces détachées en ligne à
Obtenga piezas en línea en
www.getearthquake.com
Includes Models:
Inclut le modèle / Incluye los modelos:
9800B
9800H
9800K
9800KC
GAS/OIL
RATIO
50:1
P/N: 30052
ECN: 13498
REV2: 9/9/21
© 2022 Ardisam, Inc.
All Rights Reserved
Tous droits réservés
Todos los derechos reservados

Questions and Answers

  • B
    benjamin41Aug 16, 2025
    What to do if my EarthQuake Lawn and Garden Equipment engine misses or lacks power?
    • J
      jeffrey57Aug 16, 2025
      If your EarthQuake Lawn and Garden Equipment engine misses or lacks power, consider the following: * A clogged fuel filter might be the problem. Clean the fuel tank and replace the fuel filter. * The air filter may be clogged. Clean or replace the air filter. * The spark plug may be wet, faulty, or improperly gapped. Clean, replace, or gap the spark plug.
  • N
    Nancy SimonAug 19, 2025
    What to do if the EarthQuake 9800KC Lawn and Garden Equipment auger turns, but has no power?
    • M
      melissa29Aug 19, 2025
      If the EarthQuake Lawn and Garden Equipment auger turns but has no power, the carburetor may be out of adjustment or bad, in that case, you should contact your engine manufacturer (Kohler, Briggs & Stratton, Honda). It could also be due to a broken transmission, replace the transmission. Another potential cause is worn clutch shoes, replace the clutch.
  • J
    Julie BlackAug 22, 2025
    How to start my EarthQuake 9800KC if the engine won't start?
    • K
      Kathryn BrownAug 22, 2025
      If your EarthQuake Lawn and Garden Equipment engine won't start, there are several potential causes: * The ignition switch may be off - flip the switch to the ON position. * The spark plug wire may be disconnected - connect the spark plug wire to the spark plug. * It might be out of fuel - refuel. * The spark plug could be wet, faulty, or improperly gapped - clean, replace, or gap the spark plug. * The fuel may be stale - drain the old fuel and replace it with fresh fuel, using a fuel stabilizer at the end of the season or during long-term storage.
  • K
    Kyle BestAug 25, 2025
    Why is my EarthQuake 9800KC Lawn and Garden Equipment engine hard to start?
    • W
      wwilsonAug 26, 2025
      Your EarthQuake Lawn and Garden Equipment engine might be hard to start due to several reasons: * Stale fuel could be the issue. Drain the old fuel and replace it with fresh fuel, and consider using a fuel stabilizer at the end of the season or during long-term storage. * A loose spark plug wire could also be the culprit. Make sure the spark wire is securely attached to the spark plug. * A dirty carburetor may be the cause. Clean the carburetor and consider using a fuel stabilizer with a new gas can.
  • C
    clarkkimberlyAug 28, 2025
    Why does my EarthQuake 9800KC Lawn and Garden Equipment engine run rough and flood during operation?
    • H
      hernandezkaylaAug 28, 2025
      If your EarthQuake Lawn and Garden Equipment engine runs rough and floods during operation, it might be due to a dirty air filter. Try cleaning or replacing the air filter. If the issue persists, the carburetor may be out of adjustment, in that case, you should contact your engine manufacturer (Kohler, Briggs & Stratton, Honda).
  • J
    Jennifer CarterAug 31, 2025
    What to do if my EarthQuake 9800KC engine runs, then quits?
    • J
      Jared Floyd IIIAug 31, 2025
      If your EarthQuake Lawn and Garden Equipment engine runs and then quits, it could be due to a clogged fuel filter. In this case, you should clean the fuel tank and replace the fuel filter. If the issue persists, the carburetor may be out of adjustment or bad, in that case, you should contact your engine manufacturer (Kohler, Briggs & Stratton, Honda).
  • A
    Amy WallaceSep 3, 2025
    Why does the EarthQuake Lawn and Garden Equipment auger cut slowly?
    • C
      Christine BlairSep 3, 2025
      The EarthQuake Lawn and Garden Equipment auger might cut slowly due to a few reasons: * The blade could be dull, replace it with a new one. * The fishtail point could be damaged, replace the fishtail point. * The blade might be installed upside down, install the blade right side up (bevel side down).
  • K
    kelly18Sep 6, 2025
    Why is my EarthQuake Lawn and Garden Equipment engine revving too high?
    • L
      logan16Sep 6, 2025
      If your EarthQuake Lawn and Garden Equipment engine is revving too high, the carburetor may be out of adjustment or bad. In that case, you should contact your engine manufacturer (Kohler, Briggs & Stratton, Honda).
  • T
    Terry CowanSep 9, 2025
    Why does the EarthQuake Lawn and Garden Equipment auger turn at idle?
    • R
      Robert HowardSep 9, 2025
      The EarthQuake Lawn and Garden Equipment auger might turn at idle because the idle speed is too high. Adjust the idle speed lower. Alternatively, a broken clutch spring could be the cause, replace the clutch.
  • G
    george22Sep 12, 2025
    Why does my EarthQuake 9800KC auger jump?
    • R
      Richard JenkinsSep 12, 2025
      If your EarthQuake Lawn and Garden Equipment auger jumps, it's likely due to a damaged blade. Replace it with a new blade.

EarthQuake 9800KC Specifications

General IconGeneral
BrandEarthQuake
Model9800KC
CategoryLawn and Garden Equipment
LanguageEnglish

Related product manuals