EarthWise CB20018 - Product Features and Specifications; Product Specifications; Troubleshooting Guide; Common Problems and Solutions

FEATURES
PRODUCT SPECIFICATIONS
CB20018
Input. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 V, DC only
Speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 140 MPH
Tube Length. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 in.
Weight. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4.8Ib
REAR BLOWER TUBE
BATTERY PACK
TRIGGER SWITCH
BLOWER FRONT TUBE
HANDLE
CB20018
- One Speed Switch - On/Off - Snap on tube - Rubber Molded Over Handle
TROUBLESHOOTING
Problem
- Unit does not run
Possible Cause
- Battery not making contact
- Lock off not fully operated
- Battery not installed properly
- Battery not charged
Possible Solution
- Check battery is fully inserted
- Check that lock off is fully depressed prior to moving trigger
- Check that battery is securely connected to the blower
- Check battery charging requirements
- Battery will not charge
- Battery not inserted into charger
- Charger not plugged in
- Surrounding air temperature too hot or too cold
- Insert battery into charger until red LED appears
- Plug charger into a working outlet
- Check current at receptacle by plugging in a lamp or other appliance
- Check to see if receptacle is connected to a light switch which turns
power off when you turn out the lights
- Move charger and tool to a surrounding air temperature of above 40
degree F (4,5 degree C) or below 105 degree F ( +40,5 degree C)