TROUBLE SHOOTING
Problem
Cause possible
Possible Solution
- Unit does not run - Battery pack is discharged. - Charge the battery pack.
- Battery pack temperature too high or too low. - Allow battery pack to cool down or warm up.
- Defective on/off rotary switch.
- Defective motor.
- Contact customer service.
- Impeller cover still open. - Close impeller cover and screw it down
properly.
- Unit works with interruptions - Battery pack is too hot. - Allow the battery pack to cool.
- Foreign object blocks impeller - Remove blockage (see Maintenance)
- Low vacuum capacity or vacuum
not present
- Collection bag is full - Empty collection bag
- Collection bag is dirty - Clean collection bag
- Selection lever in wrong position - Set selection lever to the vacuum symbol
- Unit clogged up or blocked by foreign object - Remove blockage (see Maintenance)
- Small or missing blowing power - Selection lever in wrong position - Set selection lever to the blowing symbol
- Speed controller in wrong position - Rotate spee d controller to high position
7
LBVM2202
To Next Page
Loading...
