Installation and removal
LED indicator
Charging
1) Removing back protective piece: hold iPad on both sides and use
thumbs to gently push off the back cover (see photo.) Cover is held
in place by two tabs.
2) Proceed to “peel” cover away from iPad.
3) Take iPad out.
Blue LED, will flash when searching paring device, will be extinguished
after successful pairing.
Red LED will always be on when charging, and will be off when full of charge.
Green LED will flash when it is powered off, and it will always be on when it
is fully charged.
When you turn on the keyboard, the green and blue LED will shine
about 3 seconds.
1. Please charge the keyboard with your iPad's charging cable.
2.Fully charge your keyboard, or charge it for more than 3 hours, before
you use it for the first time.
The keyboard charging port is TYPE C, the input voltage can not exceed
DC-5V, the keyboard will be broken if the voltage exceed the limit.
06
To Next Page
Loading...