4
Technical specificationsSafety instructions
Read the entire manual carefully before
installing and operating the product.
Observe the following instructions:
— Do not use the product if it is damaged
or does not function properly.
— Always have any repair work carried
out by an authorised electrician and in
accordance with local requirements.
— This product is intended for indoor use
in dry locations only. If placed outside
the house, it must be installed inside a
cabinet protected from the weather.
— Do not immerse the product in water or
other liquids.
— Avoid direct sunlight or heat exposure.
— Keep product away from open flames
and extreme heat.
— Make sure that children do not play with
the product.
General
Dimensions (mm): H: 95 x W: 51 x D: 30
Permitted temperature: -20 °C to +50 °C
Weight: 105 g
Supply: 85-264VAC
Installation system: TT, IT or TN
Phases: 1- or 3-phase
Current sensors
Type: CT clamps
Operation range: 0 – 100 A
Cable diameter: max 16 mm
Cable length: 1,5 m
Protection
Degree of protection: IP30
Insulation class: II
Overvoltage category: OVC II
Connection
2x RJ12
6x sensor slots
1x 12 pin expansion port
To Next Page
Loading...
