1. Change Code
a. Enter “0” six times. One beep will sound, indicating that the entry is valid and the system is
awaiting the code change.
b. Enter the existing six (6) digit code one time. One beep will sound, which indicates that the entry
is valid.
c. Enter a new six (6) digit code one time. One beep will sound, indicating the entry is valid.
d. Re-enter the new six (6) digit code. One beep will sound, indicating the codes entered in steps c
and d are the same and the code changing process is successful.
e. If two beeps sound, the code change process has been unsuccessful. The existing code is still
valid. Repeat steps a to d.
f. Record the new code.
Note:
a. Verify the new super code at least 3 times before closing the door to make sure the code is correct.
b. The system will revert to standby status if there is no key press within 10 seconds. Standby status
is indicated by two short beeps.
c. User Code can’t be 000000 or 999999.
2. Add Manager code
Note: New lock has a default manager code 1-2-3-4-5-6. If this code has been deleted, follow these
steps to add the manager code:
a. Enter the Super Code and hold down the last digit of this code until one beep sounds, followed
by two beeps.
b. Press button “1”. One beep sounds, indicating that the system is ready to receive the new
Manager Code.
c. Enter a desired six (6) digit code once. One beep sounds, indicating that the entry is valid.
d. Repeat the six digit code. One beep will sound, indicating that the six digit codes entered were
the same and the addition of the manager code was successful.
e. If two beeps sound, the programming attempt was unsuccessful. Repeat steps a through d.
3. Add User
a. Enter the manager code and hold down last digit of code until one beep sounds, followed by two
beeps.
b. Press button “1”. One beep sounds, prompting the entry of the user ID.
c. Enter a user ID (2~9). For example, press 2 to enter user ID 2, one beep sounds, indicating that
the system is ready to receive the new user code.
d. Enter a desired six (6) digit code once. One beep sounds, indicating that the entry is valid.
e. Repeat the six digit code. One beep will sound, indicating that the six digit codes entered were
the same and the addition of the manager code was successful.
f. If two beeps sound, the programming attempt was unsuccessful. Repeat steps a through e.
Note:
a. Ver ify the new code at least 3 times before closing the door to make sure the code has been
programmed correctly.
To Next Page
Loading...
Need help?
General