b. The system will revert to standby status if there is no key press within 10 seconds. Standby status is
indicated by two short beeps.
c. User Code can’t be 000000 or 999999.
4. Open Lock (Single User Mode)
To open the lock, enter user or manager code, then rotate the keypad to the right to open. After 6
seconds, the lock relocks. Rotate the keypad to the left to close.
5. Disable Manager
a. Enter the super code and hold down last digit of code until one beep sounds, followed by two
beeps.
b. Press button “2”, one beep will sound, indicating that the disabling manager is successful.
c. Enter the disabled manager code to make sure the code is disabled.
6. Disable User
a. Enter the manager code and hold down last digit of code until one beep sounds, followed by two
beeps.
b. Press button “2”, one beep will sound, prompting the entry of the user ID.
c. Enter a user ID (2~9). For example, press 2 to disable user ID 2, one beep sounds, one beep will
sound, indicating that the disabling user is successful.
d. Enter the disabled user code to make sure the code is disabled.
7. Enable Manager
a. Enter the super code and hold down last digit of code until one beep sounds, followed by two
beeps.
b. Press button “1”, one beep will sound, indicating the enabling manager is successful.
8. Enable User
a. Enter the manager code and hold down last digit of code until one beep sounds, followed by two
beeps.
b. Press button “1”, One beep will sound, prompting the entry of the user ID.
c. Enter a user ID (2~9). For example, press 2 to enable user ID 2, one beep will sound, indicating
that the enabling user is successful.
Note:
a. Ver ify the new code at least 3 times before closing the door to make sure the code has been
programmed correctly.
b. The system will revert to standby status if there is no key press within 10 seconds. Standby status is
indicated by two short beeps.
9. Delete Manager
a. Enter the super code and hold down last digit of code until one beep sounds, followed by two
beeps.
b. Press button “3”, one beep will sound, indicating the deleting manager is successful.
c. Enter the deleted manager code to make sure the code is deleted.
To Next Page
Loading...
Need help?
General