a. Enter code.
b. One beep sounds and the lock opens.
2. Dual User Mode
a. Enter both user and manager codes.
b. One beep sounds and the lock opens.
OPERATE ENTRY PAD WITH TIME DELAY & TIME WINDOW
1. Single User Mode
a. Enter code.
b. One beep sounds followed by four beeps sound indicating the controller starts Time Delay
period.
c. One beep sounds every ten (10) seconds.
d. Four beeps sound at the end of Time Delay period indicating the start of the Time Window period.
Two beeps sound every ten (10) seconds during Time Window period.
e. Enter code again within Time Window to unlock.
2. Dual User Mode
a. Enter code.
b. One beep sounds followed by four beeps sound indicating the controller starts Time Delay
period.
c. One beep sounds every ten (10) seconds.
d. Four beeps sound at the end of Time Delay period indicating the start of the Time Window period.
Two beeps sound every ten (10) seconds during Time Window period.
e. Enter both user and manager codes to unlock.
Note:
a. When unlocking by super code, the controller is unlocked without time delay and time window.
b. During the time window if the code is not entered, the controller will be locked after time window
period with four beeps sound.
c. Press button 0 to exist time delay.
14. Set TDO user
a. Enter the super code and hold down last digit of code until two beeps sounds.
b. Press button “4”, one beep will sound, prompting the entry of the TDO user ID.
c. Enter the user ID (2~9), one beep sounds, indicating that the setting of TDO user is successful.
15. Delete TDO user
a. Enter the super code and hold down last digit of code until two beeps sounds.
b. Press button “4”, one beep will sound.
c. Press button “0”, one beep will sound, indicating that the deleting of TDO user is successful.
16. Extract audit trail
a. Connect the USB receiver to the entrypad.
To Next Page
Loading...
Need help?
General