b. Enter the super code and hold down last digit of code until two beeps sounds.
c. Press button “7”, one beep will sound, followed by one more beep indicating that the extracting
is successful.
17. Recovery
a. Enter the recovery code and hold down last digit of code until two beeps sounds.
b. Press button “3”, one beep will sound, indicating that the recovery is successful.
18. Reset the Controller to Manufacturer’s Default
1. If the actuator and entry pad are securely connected and the battery is installed:
a. Remove the cable.
b. Press the reset button with a pin for about 2 or 3 times.
c. Press and hold the reset button for more than 3 seconds, then reconnect the cable, one beep
will sound, release the reset button.
d. The controller has been reset back to manufacture’s default.
Note:
If no beep sound, Repeat steps a through c.
2. Reset the lock to connect with a new entrypad.
a. Remove the entrypad.
b. Press the reset button with a pin for about 2 or 3 times.
c. Connect a new entrypad with the lock.
d. Three beeps will sound, press button “0” within 10 seconds, one beep will sound indicating
the binding is successful.
e. Enter a valid code to see if the lock can be opened, if not, refer to steps a-d above.
19. Specifications
：
Rated Voltage: DC 9V
Working Temperature: 0℃~ +49℃
Working Humidity (max): <90%
Password Length: 6 Digits
20. Installation
Please refer to:
Installation Instructions for SafeLogic D-Drive C10
V1.020190926(A)
To Previous Page
Loading...
Need help?
General