EASTONTECH EW Series - Page 10

EW-ECO SERIES OPERATION MANUAL
10
：In the parameter settings by pressing the key, set parameters most
low plus 1; in a parameter setting state press this button, the
knife value minus 1;
：In the parameter settings by pressing the key, the modified data to
give up, the last data into modified object;
：In the parameter settings by pressing the key, the modified data to
give up, the next data into modified object;
：In the parameter set state press this key, the modified data will be
saved and written to the EEPROM, and the nedxt data into
modified object;
：In the parameter set state press this key, exit parameter setup state;
the function setting screen, segmental stripping setting screen,
system setup screen. Press this key, return to work picture;
： On the standby screen, press the key, enter the system
arrangement of the picture, need to enter the password before
entering, in a setting screen, function; multistage peeling setting
picture picture, system settings, you press the key, enter the
parameter setup state;