EASTONTECH EW Series - Page 9

EW-ECO SERIES OPERATION MANUAL
9
standby state press this key, the count of 0;
：In a data input state press this key, enter the number 6; in the
standby state press this button, switch machine working mode;
：In a data input state press this key, enter the number 7; in the
standby state press this button, switch machine working mode;
：In a data input state press this key, enter the number 8; in the
standby state press this button, the machin will enter the output
settings;
：In a data input state press this key, enter the number 9; in the
standby state press this button, the machin will enter the
function setting picture;
：In a data input state press this key, removal of the input data; in
the standby state press this key, total output and the number of
full clear 0;
：In the standby state press this button, the machine will enter the
program settings;
：In the parameter settings by pressing the key, set parameters most
low plus 1; in a parameter setting state press this button, the
knife value plue 1;