High Quality, Stainless Steel
TH Series Submersible Pumps
Instructions for Operation • Safety • Warranty
Thank you for purchasing the TH series waterfall pump.
These stainless steel waterfall pumps are designed for con-
tinuous duty use. These pumps are a great choice for water-
falls, pond fountains and similar applications. The compact
design makes them great for skimmers. The pumps are built
with overload protections, thermal overload protection and
auto reset. The pumps come standard with a 2" NPT outlet.
Safety & Electrical Connections
1. Always disconnect the electricity supply before han-
dling, maintaining, repairing or installing any pond
equipment.
2. Always make sure you know the correct amps and
voltage required before installing.
3. EP waterfall pumps come in both 115 volt and 230 volt.
4. Always connect to a Ground Fault Circuit (GFCI).
5. Never let the pump run without water as this will dam-
age the impeller, over heat the pumps and possibly
burn out the pump.
6. Do not use this product in bathrooms or swimming pools.
7. Do not let the water level in your water feature fall below the top of the pump body.
8. All electrical work must be performed by a qualied technician. Always follow the National
Electrical Code (NEC) or the Canadian Electrical Code as well as all local, state and provincial
codes. Code questions should be directed to your local electrical inspector. Failure to follow
electrical codes and OSHA safety standards may result in personal injury or equipment dam-
age. Failure to follow manufacturer’s installation instructions may result in electrical shock, re
hazard, personal injury or death, damaged equipment, provide unsatisfactory performance and
may void manufacturer’s warranty.
9. Always operate the pump in a skimmer or a submersible pump screen.
TH150 • TH250 • TH400 • TH750
To Next Page
Need help?
General
