EasyStand Glider - EasyStand Glider Assembly

To Next Page

To Previous Page

EasyStand

Glider Assembly

FIG. 4

FIG. 1

FIG. 1- For International orders only: Attach the front caster

frame to the front frame with bolts and tighten securely.

FIG. 2- Attach the casters to the rear base frame. Tighten

securely using the provided wrench. Ensure the casters are

ﬂush with the rear base frame. The casters are supplied with

a locking compound pre-applied to the threaded stem. Do not

remove this material, it is important to prevent the casters

from loosening over time.

FIG. 3- Place the front frame and the seat assembly on its

side, slide the front frame into the opening of the seat assem-

bly as shown. Line up holes and insert all four bolts ﬁrst, then

place nuts onto bolts and tighten securely with hex wrench

and 19mm open-ended wrench. Place unit upright on its

wheels.

FIG. 4- Remove the ratchet handles and bolts from the glide

handles, slide the glide handles into the slots. Tighten secure-

ly. If any additional options were ordered, please refer to the

drawings on pp. 5-10. Install the seat onto the seat assembly

after all other options are added.

Front Frame

Seat Assembly

Videos on EasyStand assembly & ﬁtting can be viewed at www.easystand.com/videos

Page 3 - Assembly

FIG. 3

FIG. 2