Easysystems D1 User Manual

E8 D1 Manual
1 of 9
D1 Swing Gate Control Board Manual
Imported by www.gateopener.co.nz PO Box 9215 Tauranga New Zealand
sales@gateopener.co.nz
Warning: Insure you have sealed all means of
entry to the control box by insects and water.
Control Panel – Model D1
The Easysystems D1 control panel is specially design to match 12Vdc Arm
Gate Motor(s).
The electronic panel requires no maintenance as long as the gate operates in
proper order and is kept dry and insect free. Mount the Control box as close to
the motor(s) (maximum 10m cable) as possible connected with minimum
1.5mm 2-core electrical cable to reduce any voltage drop which will affect the
performance of the system. 2.5mm to 4mm house cable is commonly used.
1. Make sure all wiring works are correct and in good condition before
supplying the mains power to the control panel.
2. Turn OFF the power when doing any maintenance.
3. Ensure the control panel box free from water leakage to avoid short
circuiting.
4. Do not supply mains power directly to the motor.

Easysystems D1 Specifications

General

Brand	Easysystems
Model	D1
Category	Control Panel
Language	English

Summary

Control Panel Overview

Model D1 Description

Details about the Easysystems D1 control panel, designed for 12Vdc Arm Gate Motors.

System Components and Configuration

Battery and Transformer Installation

Guidance on installing the battery and connecting the transformer.

DIP Switch Configuration

Explanation of DIP switch settings for controlling gate operations and features.

Remote Control and System Configuration

Remote Control Functionality

Understanding the 12Vdc remote transmitter's buttons and functions.

Adding and Changing Remotes

Procedures for adding new remotes and changing system codes.

Installation and Wiring Guidance

Important installation notes for arms, condensation, and wiring double gates.

System Operation and Setup

Motor Rotation Direction Check

Procedure to ensure correct motor rotation direction after power connection.

Double Gate Operation Setup

Step-by-step guide to set up and calibrate the system for double gate operation.

System Reset Procedure

Instructions for resetting the system's memory and open/close calibration.

Gate Operation Modes and Interfaces

Single Gate Operation Setup

Procedure for configuring the system for single gate operation.

12Vdc Battery Power Mode

Details on system operation when running solely on 12Vdc battery power.

External Auto-Close Switch

Configuration of the external switch for a 30-second auto-close function.

Optional 12V Device Connection

Guidelines for connecting optional 12Vdc devices protected by a 1 Amp fuse.

Keypad Gate Control Interface

Connecting a keypad to control gate opening for single or double gates.

External Controls and Safety Features

Exit Button and Intercom Connection

Wiring exit buttons or intercoms for gate release and pedestrian access.

Close Switch Port Functionality

Using the Close Switch Port for single or double gate closing operations.

Safety Infrared Beam Installation

Connecting safety infrared beams and managing the jumper wire.

Lock Mechanism Integration

Connecting a 12Vdc lock for enhanced security and its DIP switch configuration.

Loop Detector and Free Exit Function

Connecting loop detectors and understanding the Free Exit Mode for gate operation.

Accessory and Lighting Connections

External Light Connection

Connecting a 12Vdc relay for external lights like pillar lights.

DIP Switch 3 & 4 Lamp Settings

Configuring DIP switches 3 & 4 for lamp control and power saving modes.

Troubleshooting and Problem Resolution

Transmitter Response Issues

Resolving problems where the system does not respond to the transmitter.

Gate Opening Without Closing

Troubleshooting steps for when the gate opens but fails to close.

Partial Gate Operation Problems

Diagnosing and fixing issues where gates stop mid-cycle or incompletely.

Smooth Gate Travel Issues

Addressing problems related to uneven or obstructed gate movement.

Double Gate Closing Synchronization

Resolving issues where one gate closes out of sync in a double gate setup.