3 of 12
Full-Open Position
In full-open position, the gates can either be hard stopped by a peg / stopper, or be
stopped by the internal built-in mechanism at the end of the retracted arm.
You can however install another gate stop to the full-open position.
GATE STOP AT THE CENTRE OF DRIVEWAY
METHODS TO INSTALL GATE STOP
Gate Tab
You may need to fit gate tabs to the bottom of your gates to contact the gate stop. If your
driveway is sloping to one side then you need to have one gate contact the gate stop while
the second gate contacts the first gate instead of the gate stop.
GATE CONTACT
GATE TAB
To Next Page
Loading...