8 of 12
Step 5
Clamp the gate bracket to the gate in the centre of the mark of the white tape.
Step 6
Position the post bracket vertically above the template screw and against the post. You can
clamp/nail the post bracket at ground level to complete this step prior to re-locating the
bracket to the correct height later.
Step 7
Place the gates in the closed position. Place your level on top of the gate bracket
mounting pin and mark a level line to the gate post. Add 10-15mm HIGHER to the level
mark and this will be the centre of your post bracket.
To Next Page
Loading...