EasyWalker MINI - Using the Sun Canopy

EN
EN - 8
openings (image 35). Make sure that both sides have the same height.
Close the rear of the seang.
Aach the waist belts to the frame of the seat. Put each waist belt
through the appropriate hole in the seang. (image 51). Make a loop
around the tube, then through the plasc ring and aach the Velcro
strip (image 52). Make sure the waist belts are both correctly aached.
Aach the crotch belt to the seat pad by pung the belt through the
seat pad and aach the Velcro underneath (image 53).
Tip: It might help to detach the seat pad fabric from the seat frame
when aaching the crotch belt.
Adjusng the height of the shoulder straps:
You can adjust the height of the shoulder straps by opening the rear of
the seang (image 34) and adjust the height of the shoulder straps by
choosing dierent openings (image 35). Make sure that both sides have
the same height. Close the rear of the seang.
Adjusng the length of the straps:
You can use the sliding buckles on the shoulder straps, the waist straps
and the crotch strap to adjust the ve-point safety harness (image 36).
Always make sure that the harness ts your child exactly.
Sun canopy
IMPORTANT: A small child has a very sensive skin. Never leave your
child unaended in the sun.
IMPORTANT: Always use the sun canopy.
Aach the sun canopy on the easywalker MINI stroller by placing the sun
canopy hinges over the knobs on the frame of the rear part of the sun
canopy. Then use the zipper to fasten the hood (image 37).
The sun canopy is height adjustable. Grab the bar at the back of the sun
canopy and move it up or down unl it is in the desired posion (image
18). With the extra extension (image 38) you can provide extra shade for
your child. For a compact fold put the sun canopy in lowest posion.