7
Series 26 - Model 26000 Multiple Gear Pump
20 Tap
front adapter plate
with a soft faced hammer to loosen
and remove adapter plate. After removing adapter, turn it over
and remove the
second o-ring seal
.
21 Remove
first pump body
from front plate.
22 Remove
first pump idler gear
and
input drive gear
assembly
along with
wear plate
and
o-ring seal
from front
plate.
15 Remove
second or middle pump body
from second set of
gears.
16 Remove
idler gear assembly
from wear plate and
drive
gear
from input shaft.
17 Remove the next (second)
wear plate assembly
from the
adapter.
18 Next, use a pencil magnet to remove the
second drive key
from the pump shaft.
19 Remove the
o-ring seal
from the front adapter plate.
To Next Page
Loading...
Need help?
General
