6
2000 Series Disc Valve Motors
2000 SerieS diSc valve geroler motor C-MOLO-TM010-E1 June 2018 www.eaton.com
Seal
Valve Drive
Valve Plate
10. (A) Remove the valve plate.
11. (A) Remove the 76,0 [3.00] diameter seal from
valve plate.
12. (A) Remove the valve drive.
Seal
Drive
Retainer
Geroler
Valve
Plate
Valve
Drive
Retaining
Ring
10. (B) Remove the Valve Drive and Retaining Ring
11. (B) Remove valve plate and 76.0 [3.00] diameter seal
from valve plate
12. (B) Remove drive retainer
Seal
Seal Geroler
13. Remove the Geroler. Be sure to retain the rollers in
the outer ring if they are loose.
14. Remove the drive.
15. Remove the 76,0 [3.00] diameter seal from
wear plate, see Figure 7.
Bearing
Housing
Seal
Shaft Face Seal
Wear
Plate
16. Remove the wear plate.
17. Remove the shaft face seal from the wear plate.
18. Remove the 76,0 [3.00] diameter seal from
bearing housing.
Bearing
Housing
Shaft and
Bearing
Assembly
19. You may need a press to remove shaft and bearing
assembly from bearing housing. (Key must be
removed before removing shaft.)
Bearing Housing Shaft Seal
Back-up Washer
Exclusion
Seal
20. Use a small screwdriver to remove shaft seal,
back-up washer and exclusion seal from bearing
housing, see Figure 10. Do not damage bore of
housing.
ote:N Individual parts of shaft and bearing assembly are not
sold separately. Replace as a unit.
Disassembly
Figure 6 (A).
Figure 6 (B).
Applicable for displacement codes
021, 025 and 040
Figure 7.
Figure 8.
Figure 9.
Figure 10.
To Next Page
Loading...
