4
6000 Series Char-Lynn Motors
Tools
Tools required for disassembly and reassembly
—Torque wrench (90 Nm [800 lb-in] capacity)
—305 to 406 mm [12 to 16 inch] breaker bar
—3/4 inch and 1/2 inch sockets
—Small screwdriver (150 to 200 mm [6 to 8 inch] long,
6 mm [1/4 inch] blade)
—3/16 inch Hex Key
—Hydraulic Press — 1335 N [300 lbf]
—Plastic or rubber hammer
* —Bullet (600464) for 1-1/2 inch diameter shafts
*Available by special order through our service department.
9,52 [.375]
Grind flat spots on each side
Approx. 12,7 [.50]
215,9 [8.50]
(273,05 [10.75] required for 985 cm
3
/r [60.0 in
3
/r] Displ.)
Alignment studs (2)
25,4 [1.00]
1/2-20 UNF thread
12,7 [.50] Dia. Steel Rod
Wheel motor and bearingless motor repair information on page 12.
Shuttle valve and seal guard repair information on page 13.
Seal guard reference on page 13.
Shaft Face Seal
Dust Seal
Shaft Seal
Special Global Mount
Shaft and Bearing
Assembly
Seal
Retainer, Front
Screw, Cap
Parts Drawing — Big 6
To Next Page
Loading...
