Eaton Cutler-Hammer FP-6000 Series - Page 7

IB02602004E For more information visit: www.eaton.com
Instructional Literature
Effective: May 2008 Page 7
Instructions for the FP-6000 Protective Relay
1.9 Function Matrix
All of the protective functions found in the FP-6000 are listed in the matrix below. Each entry includes the numbers for the pages in
the manual that provide additional information for that function.
Table 3. Function Matrix.
DEVICE NUMBER PROTECTIVE FUNCTION CONFIGURE IN: PAGE REF.
25 Sync Check Protection Sync Check Menu 69
27A-1 Auxiliary Vx Undervoltage Protection Aux V Menu 66
27A-2
27M-1
Auxiliary Vx Undervoltage
Main Undervoltage
Protection Alarm Menu
Protection Main V Menu
70
66
32-1
32-2
Power Protection Protection Power Protection Menu 67
32-3 Power Protection Protection Alarms Menu 70
46-1 Current Unbalance Protection Unbalance Menu 65
46-2 Current Unbalance Protection Alarm Menu 70
47-1 Voltage Unbalance Protection Unbalance Menu 65
47-2 Voltage Unbalance Protection Alarm Menu 70
50BF Breaker Failure Protection Breaker Failure Menu 67
50P-1
50P-2
50P-3
Phase Instantaneous Overcurrent
with Directional Supervision (67)
50P-1 50P-2 in Protection Phase Overcurrent Menu
50P-3 in Protection Alarm Menu
63
63
70
50R-1
50R-2
50R-3
Residual Ground Instantaneous Overcurrent
with Directional Supervision (67)
50R-1, 50R-2 in Protection Phase Overcurrent Menu
50R-3 in Protection Alarm Menu
65
70
50X-1
50R-2
50R-3
Measured Ground Instantaneous Overcurrent
with Directional Supervision (67)
50X-1, 50X-2 in Protection IX Measured Overcurrent Menu
50X-3 in Protection Alarm Menu
64
70
51P Phase Inverse-Time Overcurrent
with Directional Supervision (67)
Protection Phase Overcurrent Menu 63
51R Residual Ground Inverse-Time Overcurrent
with Directional Supervision (67)
Protection IR Residual OC Menu 65
51V/51P2 Phase Inverse-Time Overcurrent with Directional
Supervision (67) & Voltage Restrained Overcurrent
Voltage Restraint in ProtectionPhase Overcurrent Menu
for 51P2
63
51X Phase INverse-Time Overcurent with
Directional Supervision (67)
Protection IX Measured OC Menu 64
55A Apparent Power Factor Protection Power Factor Menu 68
55D Displacement Power Factor Protection Power Factor Menu 68
59A-1 Auxiliary Vx Overvoltage Protection Aux V Menu 66
59A-2 Auxiliary Vx Overvoltage Protection Alarm Menu 71
59M-1 Main Overvoltage Protection Main V Menu 66
59M-2 Main Overvoltage Protection Alarm Menu 70
59N-1 Neutral Overvoltage Protection Neutral V Menu 66
59N-2 Neutral Overvoltage Protection Alarm Menu 71
67P Phase Directional Supervision of
50P-1, 50P-2, 50P-3, 51P, 51P2
Directional setpoints in System Configuration Menu
Configure 50P & 51P functions in Protection OC Menu
63
67G
(67pol,
67Q, 67V)
Ground Direction Supervision of
50R-1, 2, 3 & 50X-1, 2, 3, 51X, 51R
Directional Setpoints in System Configuration Menu
50 & 51X & R Functions in Protection OC Menu
63
64
65
810-1
810-2
Over Frequency
Over Frequency
Protection Frequency Menu
Protection Alarm Menu
67
71
81U-1
81U-2
Under Frequency
Under Frequency
Protection Frequency Menu
Protection Alarm Menu
67
71
Breaker Alarms Systems Alarm Menu 77
Cold Load Pickup Cold Load Pickup Menu 87
LOP
THD
Loss of Potential Used to Block Voltage Restraint
Power Protection Functions on Voltage Loss
Total Harmonic Distortion Alarms
Protection Main Menu
System Alarms Menu
66
76
Watt, VAR, VA Power Alarms System Alarms Menu 76
Zone Interlocking Protection Zone Interlocking Menu 68