Zero 88 FLX S Lighting Console – User Manual Page 37 of 47
Inputs & Outputs
Inputs and Outputs within the Setup menu allows you to
manage the DMX Output of the FLX S. This screen does
not cover networking, which is covered in other areas
within Setup.
The “Inputs & Outputs” window
DMX Outputs
FLX S has two DMX Outputs on the rear of the console. By
default, these both output Universe 1, unless FLX S has
been upgraded to 2 universes. Each of the outputs can be
mapped to either of the DMX Universes. For example, on
smaller rigs you may choose both outputs to be the same
Universe 1 so it doesn’t matter which output you plug your
rig into. The default setting is “Automatic”, which means if
something is patched on Universe 1 it will be outputted on
DMX Output 1, and if something is patched on Universe 2,
it would be outputted on DMX Output 2 (if upgraded).
Defaults
Defaults within the Setup menu allows you to change the
default times and settings given when you program Cues.
Changing the default settings will never change Cues
which have already been programmed. Only future Cues
will be affected by a change in defaults.
The “Defaults” screen within Setup
To Next Page
Loading...
