100
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Input Shaft | Removal and Installation TRSM0940
6. Remove the Input Shaft Spacer.
7. Remove the snap ring retaining the Input Shaft to the
Main Drive Gear.
8. Remove the Input Shaft from the Main Drive Gear.
9. Inspect the Input Shaft Bushing, replace if damaged.
Input Shaft Installation
1. If necessary, complete installation of the Input Shaft
Bushing.
2. Install the Input Shaft into the Main Drive Gear splines.
3. Install the snap ring that retains the Input Shaft to the
Main Drive Gear
4. Install the Input Shaft Spacer.
To Next Page
Loading...