46
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
VCS/VMS Auxiliary Section Removal and Disassembly | Auxiliary Section Service Procedures TRSM0940
11. If necessary, secure the Countershafts in a vise and
remove both the front and rear bearings from the
shafts with a bearing separator and jaw pullers.
12. Remove the 1 ½” nut retainer that was loosened in step
6.
13. Remove the washer and dowel pin from the Auxiliary
Mainshaft
To Next Page
Loading...