2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
47
TRSM0940 Auxiliary Section Service Procedures | VCS/VMS Auxiliary Section Removal and Disassembly
14. Remove the Range Synchronizer Assembly with the
Range Yoke from the Output Shaft.
Note: For disassembly and assembly of the Synchro-
nizer, please refer to the “How to disassemble the
Synchronizer Assembly” section.
15. Remove the Low Range Gear and Coupler Assembly.
16. Using a punch and hammer, drive the two coupler pins
from the front of the coupler. Align the coupler splines
with the washer splines and remove the range coupler
from the Low Ranger Gear (Reduction Gear).
17. Remove the bushings from inside the coupler if neces-
sary.
To Next Page
Loading...