2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
111
TRSM0940 Removal and Installation | Electronic Clutch Actuator (ECA)
ECA Removal
Warning: Ensure the Hand Hole Cover is closed when
removing the ECA.
1. Disconnect the negative battery cable.
2. Disconnect the 8-way and 3-way connectors from the
ECA.
Note: Some models do not use a shield.
3. Remove the 4 cap screws from the ECA Shield and
remove shield.
4. Remove the 4 cap screws from the ECA mounting
flange.
To Next Page
Loading...