2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
57
TRSM0940 Auxiliary Section Service Procedures | VCS/VMS Auxiliary Section Assembly and Installation
16. Install the large flat washer 17. Select the front tapered Output Bearing (bearing with
longer rollers) With the tapered side up, use heat, or a
small punch to install the Output Shaft Rear Bearing.
Note: A Bearing Driver can also be used to seat the
bearing, however if using a bearing driver, install the
Bearing inner spacer prior to driving to avoid getting
the driver stuck on the shaft.
To Next Page
Loading...