2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
87
TRSM0940 Auxiliary Section Service Procedures | MHP/MXP/VHP/VXP Auxiliary Countershaft Installation
Range Cylinder and Piston Installation
1. To assist in the installation of the Range Cylinder, place
the Auxiliary section in a vice.
2. Position a new gasket on the range Cylinder Mounting
Surface of the Auxiliary Case.
3. Install the Range Cylinder through the Range Cylinder
Bore on the Auxiliary Case housing. Position the Range
Yoke Fork inside the open section of the cylinder.
4. Install Range Yoke Bar from the rear of the Auxiliary
case.
Note: Ensure that the Yoke Bar passes through the eye
of the Yoke fork.
5. Align the 2 groves on the Yoke Bar and install the 2
retaining bolts through the bores on the Range Yoke
Fork.
6. Install new O-rings on the ID and OD of the piston, then
lubricate with silicone.
To Next Page
Loading...