134
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
X-Y Shifter | Removal and Installation TRSM0940
4. Position X-Y Shifter on the Shift Bar Housing. Using a
9/16” socket, install mounting cap screws and tighten
in a cross pattern as follows:
• Tighten to 30–35 lb-ft (45–60 N•m).
5. Reconnect the Rail Position Sensor and Gear Position
Sensor.
6. Reconnect the Transmission Harness to the Rail Select
and Gear Select Motors. Using cable ties, secure motor
wires to the Transmission in their previous position.
7. To operate properly, the system must be calibrated as
follows:
Important: X-Y Shifter must be calibrated before the
vehicle is placed into operation.
• Turn ignition switch on. Allow the Transmission to
power up.
• Turn ignition switch off. Wait 2 minutes.
To Next Page
Loading...