154
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
Gear Position Sensor | Removal and Installation TRSM0940
Gear Position Sensor Removal
1. Disconnect the Transmission Harness from the Gear
Position Sensor.
2. Using a 5/32” hex key wrench, remove the two (2) sen-
sor hex key mounting screws.
Caution: Carefully allow sensor to rotate to a relaxed
position, or sensor can snap when the hex key mount-
ing screws are removed.
3. Remove the Gear Position Sensor and gasket from the
housing.
To Next Page
Loading...