2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
155
TRSM0940 Removal and Installation | Gear Position Sensor
Gear Position Sensor Installation
1. Align the sensor tabs with the slots in the X-Y Shifter
Rail. Then, insert Gear Position Sensor, with gasket,
into its mounting location.
Note: Install sensor so the connector opening faces the
front of the Transmission.
2. Using a 5/32” hex key wrench, install the hex key
mounting screws and tighten to 21–27 lb-in (2.3–3.0
N•m).
Caution: Carefully hold sensor in position while install-
ing hex key mounting screws, or sensor can snap.
3. Reconnect the Transmission Harness to the Gear Posi-
tion Sensor.
To Next Page
Loading...