196
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
2022.10.7
MHP/MXP/VHP/VXP Splitter Cylinder | Disassembly and Assembly TRSM0940
4. Position new gasket on the Cylinder Housing, and
install the Splitter Cylinder
5. Install O-Ring on the end of the yoke bar inside of the
Cylinder Housing
6. Install new O-rings on the ID and OD of the piston, then
lubricate with silicone.
7. Install the piston into the Splitter Cylinder with the
recessed side facing the rear of the transmission.
8. Secure piston with the 3/4 lock nut. Torque to 30-36
lb-ft (41-49N•m).
To Next Page
Loading...