2022.10.7
© 2022 Eaton Cummins Automated Transmission Technologies. All rights reserved.
195
TRSM0940 Disassembly and Assembly | MHP/MXP/VHP/VXP Splitter Cylinder
6. Remove the Piston from the bore of the Splitter Cylin-
der.
Note: If spool valve needs to be replaced, it must be
done as an entire unit which is part of splitter cover
Splitter Cylinder Assembly
1. Install the Splitter Sliding Clutch on the Splitter Yoke
Fork and engage into the Splitter Gear to maintain posi-
tion.
2. Install small O-ring in the Cylinder Housing Bore if pre-
viously removed.
3. On the Piston O.D., install the Piston O-ring if previ-
ously removed.
To Next Page
Loading...