i-on30EX Installer Menu
Page 33
1
Appears only when device learned in.
2
Appears only in a Partitioned system.
3
Appears only in a Level Setting system.
4
Appears only if Exit Mode is “Final Door” “Lock Set” or “Exit Terminate”.
5
Appears only if Exit Mode is “Timed Set” or “Silent Set”.
6
Appears only when System Options – Confirmation Mode is “Basic”.
7
Appears only if System Options – Confirmation Mode is either “DD243” or “BS8243”.
8
Appears only if System Options – Confirmation Mode is “BS8243”.
9
Appears only when Masking is ON.
10
Appears only in EUR version.
11
Appears in this position only in a part setting system.
12
Appears only if communications module fitted, or if using i-on30EXD with certain commands (see Table 2).
13
Options visible depend on communications module fitted, see Table 2.
14
Appears only when Report Type=Fast Format
15
Appears when Report Type=CID or SIA
16
Appears only when Static Test call disabled.
17
Appears only when Dynamic Test Call is disabled.
18
Appears only if Report Mode = Fast Format AND Confirmation Mode = Basic
19
Shows “None” on i-on30EXD.
20
Must be activated by a Eaton’s Security Business External Support Manager.
21
Appears only for KEY-KPZ01 keypads
22
Appears for KEY-K01, KEY-KP01 and KEY-KPZ01.
23
Appears for KEY-KP01 and KEY-KPZ01.
Table 2. Menu Options Available with Communications Modules