Need help?Do you have a question about the Eaton i-on40 and is the answer not in the manual?
General| Zones | 40 |
|---|---|
| Partitions | 4 |
| Users | 50 |
| Radio Frequency | 868 MHz |
| Power Supply | 230V AC, 50Hz |
| Operating Temperature | -10°C to +55°C |
| Communication | Ethernet, PSTN, GSM |
| Outputs | 4 programmable outputs |
| Battery Backup | 12V 7Ah |
| Event Log | 1000 events |
Procedures for mounting the control unit case and tamper.
Guidance on siting, fitting, and connecting keypads.
Instructions for safely connecting the control unit to the mains power.
Details on wiring different types of zones to the control unit.
How to connect optional wired components like speakers and sounders.
Instructions for installing plug-on communication modules.
Guidance on installing the standby battery.
Steps for powering up the system for the first time.
Procedures for testing and finalizing the system setup.
How to access the system's installer configuration menu.
Procedures for exiting the installer menu and saving settings.
Critical information on how changes are stored and lost.
Steps to reset access codes if lost, reverting to factory defaults.
To Next Page
