Installation i-on40
Page 20
Step 9. Commission the
System
After installing the control unit you should
commission the alarm system as follows:
1. Use the Installer Menu (see Chapter 4) to
teach the control unit the identity of its radio
detectors and any other peripherals. See the
installation instructions supplied with each
detector or peripheral.
2. Install detectors and peripherals at their
selected locations.
3. Use the Installer Menu – Test option to:
a) carry out a walk test of the detectors.
b) test the operation of any other peripherals.
4. Program the system to suit user requirements.
See the i-on Range Engineering Guide for a
detailed description of the Installer Menu.
5. Assemble and close the control unit:
a) Hook the lid of the control unit into the
bottom of the case.
b) Close the lid and then tighten the two fixing
screws.
NOTE: It is possible, for convenience, to place
links over tamper contacts to inhibit tamper alarm
during installation. Because of this feature make
sure you test all lid tampers before completing
installations, to ensure that no links are left fitted.
Figure
Replacing the control unit lid.
6. Leave the Installer Menu.
The red LEDs should go out, and the rim of
the navigation keys glow green. The system is
now ready to hand over to the user.
7. Instruct the user on how to operate the
system. See the i-on Range Administrator’s
Guide. If necessary, show them how to set the
time and date on the system.
Remember to leave the i-on Range
Administrator’s Guide with the user.
To Next Page
Loading...
